Introduction to Drilling with Casing Technology


Description

This fundamental course begins with an introduction to the DwC industry, key benefits of the technology, and the primary DwC systems employed by various operators. This is followed by selection of equipment for setting up a competent DwC system comprising of surface casing drive and handling equipment and downhole components. Various engineering calculations will also be discussed. At the end of the course students will be given an assessment test.

Topics Include:

  • Drillability analysis, drill bit knowledge
  • Bit record and dull grading, basic log interpretation, and drilling exponent
  • Casing drill bit and casing drives
  • DwC Operations and economics,
  • Hydraulics, torque and drag analysis, cementing, and drilling with liner

Learning Level

Introductory

Course Length

2 Days

Why Attend?

You will gain an understanding of the well selection, economics, pre-job engineering, equipment selection, and preparation needed to ensure the successful execution of a casing while drilling project.

Who Should Attend

This course is intended for drilling, application, and field engineers and, wellsite supervisors and managers involved in preparation, engineering, and execution of a casing while drilling project.

CEUs

1.6 CEUs (Continuing Education Units) awarded for this 2-day course.

Cancellation Policy

All cancellations must be received no later than 14 days prior to the course start date. Cancellations made after the 14 day window will not be refunded.  Refunds will not be given due to no show situations.

Training sessions attached to SPE conferences and workshops follow the cancellation policies stated on the event information page.  Please check that page for specific cancellation information.

SPE reserves the right to cancel or re-schedule courses at will.  Notification of changes will be made as quickly as possible; please keep this in mind when arranging travel, as SPE is not responsible for any fees charged for cancelling or changing travel arrangements.

We reserve the right to substitute course instructors as necessary.

Full Regional cancellation policies can be found at the “Cancellation Policy” link on the SPE Training Course Catalog page: http://www.spe.org/training/catalog.php.

Instructors

Ming Zo Tan is the global application engineering manager for Weatherford Drilling with Casing product line. He joined Weatherford in 2003 as a DwC product line manager. Recently, he focuses on nurturing application engineering teams in various geographical regions besides being actively involved in the development of new products and engineering tools. Prior to Weatherford, he held various positions within Halliburton, being a drill bit optimization engineer, bit designer, and rock strength specialist. He has 15 years of oilfield experience.

Tan holds a BS degree in petroleum engineering, coauthored several technical papers, and is a co-owner of a US patent.

Steve Rosenberg is the US region product line manager for Weatherford’s Drilling with Casing division. He has over 25 years of experience in the oil and gas industry, previously holding drilling engineering positions with Diamond Offshore and Conoco. Rosenberg is regarded as a subject-matter expert in casing and liner drilling applications. He has written and coauthored several technical papers on these subjects as well as being a US patent holder (Patent No. 7,857,052 B2, Stage Cementing Methods Used in Casing while Drilling).

Rosenberg holds BS degrees in petroleum engineering from Mississippi State University and in biology from St. Lawrence University, Canton, New York.