A New Method for Leak Detection in Gas Pipelines
Two types of approaches—physical inspection and mathematical-model simulation—are used to identify a leak in a gas pipeline. The former method can result in an accurate detection of the location and the size of the leak, but comes with the expense of production shutdown and the high cost/long time to run the physical detection, which is very crucial in a long-distance gas pipeline. The latter approach detects a gas leak by solving the governing equations, thus leading to quick evaluation at much lower costs, but with higher uncertainties. Our literature review indicates that a simple, practical, and reliable method to detect a gas leak under the conditions of unknown inlet or outlet gas rate, or unknown inlet or outlet pressure, is highly desirable.
In this study, we develop single and multiple rate test methods to detect leaks in a gas pipeline. By conducting multiple rate tests, the location and size of leaks can be detected. The new method can be applied under the conditions of no inlet or outlet rate available or no inlet or outlet pressure available. Because these conditions are not uncommon in gas-pipeline transportation, our method provides a quick and low-computational-cost approach to detect leaks corresponding to different scenarios.
Because of its efficiency, cleanliness, and reliability, natural gas supplies nearly one-fourth of all energy used in the United States and is expected to increase by 50% within the next 20 years (Anderson and Driscoll 2000). New gas-delivery infrastructure is constructed to transport more natural gas to terminals far away from the production site. At the same time, existing gas-delivery infrastructure is aging rapidly. Ensuring natural-gas-infrastructure reliability is one of the critical needs for the energy sector. Therefore, the reliable and timely detection of leakage from a newly-built gas pipeline during startup, and the failure of any part of the old pipeline, is critical to the flow assurance of the natural-gas infrastructure.
Traditionally, there are two types of approaches to detecting leaks in a gas pipeline; one is physical inspection to identify the location and size of the leak, and the other is mathematical modeling with numerical simulation. Physical inspection consists of gas sampling; soil monitoring; flow-rate monitoring; and acoustic-, optical-, and satellite-based hyperspectral imaging. Usually, the physical inspection can result in an accurate detection of the location and size of a leak, but this comes with the expense of production shutdown and the high cost/long time to run the physical detection, which is very crucial in a long-distance gas pipeline. The mathematical-modeling approach detects a gas leak by solving the governing mass-conservation, momentum-conservation, and energy-balance equations, thus leading to a quick evaluation at much lower cost. It also has the advantages of monitoring the system continuously and noninterference with pipeline operations. One of the limitations of the modeling method is that it requires flow parameters, which are not always available. Leak detection from mathematical modeling also has a higher uncertainty than that from physical inspection.
Phillips 66 Forms JVs To Boost Takeaway Capacity from Bakken and Permian
Phillips 66 and partners in two separate joint ventures are building the Red Oak and the Liberty pipeline systems to deliver a total of approximately 750,000 BOPD to the US Gulf Coast with startup of service in early 2021.
Cactus II Pipeline To Start Partial Service in the Permian by Year End
Approximately 90% of construction work has been completed on the pipeline, which is expected to transport up to 670,000 BOPD from the Permian Basin to the US Gulf Coast. Cactus II is one of several pipelines aimed at alleviating takeaway concerns in the Permian.
Can Robots Improve Above-Water Riser Inspections?
The criticality of above-water riser hull piping requires frequent inspections. Traditional manual inspection methods present safety and efficiency concerns, but work is being done to see if robotic technologies—such as drones and crawlers—can do the job as good as, or even better, than humans.
Don't miss out on the latest technology delivered to your email every two weeks. Sign up for the OGF newsletter. If you are not logged in, you will receive a confirmation email that you will need to click on to confirm you want to receive the newsletter.
04 June 2019
05 June 2019